Router Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
17 Posts
Discussion Starter · #4 ·
50 inch x gantry 100 inch y side helical rack with direct drive all extruded aluminum nema 34 steppers proximity sensors ,touch plate ethernet smooth stepper @Bob spindle control .Remote handwheel mach 3 controller with v carve pro
Table made with 1.5x 3 square tube and supported laterally with 1/8 3 inch angle so i wont need centre support .
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top