Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Im trying to form a cap for a fence that I have built with 4x4 posts 2x4 rails and 5/4 deckboard fence posts. The plan was to rip 1" cuts over and over until I have cleared out a one inch deep track 6.25" wide leaving 1 and 5/8" inches on either side of a 2x10. It takes a little over an hour to do one 16 footer and that doesn't include cleaning it up. Does anyone have any thoughts? I have 300' to go.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top