Router Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
Have thought about doing one of these for a while. Had some time between projects so gave it a try. Fingers are all 1/2" wide. Worked great and only required light mallet taps to make the fit. Had on chip out issue but I did not score the cut line and pushed the router a little to hard/fast. Now will make 5/8", 3/4", 7/8" and 1" fingers to allow lots of versatility. Thanks for looking.
 

Attachments

·
Registered
Joined
·
786 Posts
thx for sharing
 

·
Registered
Oliver (Prof. Henry)
Joined
·
2,217 Posts
How are the fingers attached? I can't quite tell by looking at the photos.
 

·
Registered
Joined
·
402 Posts
very interesting jig. The fingers are made of MDF? Why are they so long?
 

·
Registered
Joined
·
23 Posts
Discussion Starter #8
The fingers are long to allow for thicker wood and doing both boards from one side by offsetting one of the two boards. And to provide good balance for the router.
 
1 - 9 of 9 Posts
Top