Router Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
2,605 Posts
Discussion Starter · #1 ·
When making a box with an I Box do you let the fingers come out however they fall or center them on the width of the board? I am making the first box out of ply and it will be 5" X 5" X 12" long. It's a recipe box.
 

· Registered
Joined
·
2,605 Posts
Discussion Starter · #3 ·
I'm not sure how you would center them but I've only used mine a few times. You can only start one way that I know if. I've made mine wider than I needed and trimmed them after. Especially if you want the lid to box line to be in a certain relation to the position of the fingers.
Chuck, in this video it shows you how to center the fingers in a given width. I really wanted to see what others were doing. to find out how to center it go to about 38 minutes into the video and that will put you close.

 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top