Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,663 Posts
Not so sure you'd want to cut angled slots on the table - assuming you mean slots that are not at 90 degrees to the material surface. If so, there was an article on making an angled tower a month or so ago - I think in Popular Woodworking - I'll look for it and post it when I find it - should be this evening - but they were doing exactly what you're asking about using an angled jig that the router base would ride on to cut those angled slots or rabbits. They also cut angled mortises, tongues and through mortises - all at 3 degree cut angles - with handheld router and jig set-up.
 

·
Registered
Joined
·
1,663 Posts
OK - it was Woodworkers Journal, December 2005 issue -

http://www.woodworkersjournal.com/plans/index.cfm/plan_details/5/83/1893

Looks like you can order the back issue if you can't find your copy, or
Let me know and I can try to forward it to you.

I've never done it myself, but was thinking about building that tower just cause I liked the way it looked and wanted to practice on their joinery. Particularly the through mortises and angles.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top