Router Forums banner
1 - 10 of 10 Posts

·
Official Greeter
Joined
·
19,746 Posts
Great result, Rusty.

Can you elaborate on the method used?
 
  • Like
Reactions: Rusty Nesmith

·
Registered
Joined
·
140 Posts
Discussion Starter · #4 ·
Yes I have a laser that mounts to my CNC. I do all of the programming in the CNC software and it controls the laser. Then I put in an end mill bit so I can cut out a perfect circle.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top