Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
387 Posts
Hi Shawn:
I'll put my 2 bits in and hope it helps. Straight bits are used to rout a dato or rabbit
cuts, and are used to cutslots through materials as needed. With a bushing they can be used to follow a template. Round over bits are used to take the edges off, and
provide a decorated edge. Dove tail bits are usually used with a dovetail jig for
dove tailing drawers project sides etc. The V groove bit at 90 degrees can be used
to cut 45 degree parts that would then form a miter. Those V bits are used in doing
lettering, and decoration as well.

Hope this helps, Woodnut65
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top