Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter · #1 ·
OK,,,,i bought a little set of router bits which contained 5 carbide bits. the bits in the set are as follows: 5/16" straight, 3/8" straight, 1/8" rounding, 1/2 dovetail, and 1/2" 90 degree v groove.

could someone please tell me how i can find out when and when not to use each of these bits? i have no clue when to use what......

and help would be appreciated,,,,,,thank you

shawn
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top