Router Forums banner
1 - 1 of 20 Posts

· Banned
666 Posts
Router Table

DONALD said:
I have a makeshift work table that I use mostly with my CMS but its handy anytime I need a large flat surface to work on. I attached a 2x6 to a piece of 3/4 inch plywood about 4'x6'. I open the jaws of my workmate....put the 2x6 in and close the jaws. I take it apart when I'm thru using it and prop it against the wall. Works for me.
I add a piece of 25mm MFD to my Triton table then I have my router table for hand held projects also as an assembly table. The 25mm gives rigidity to the top and I also insert 'tee nuts' which I use regularly for holding down material ready to be routered.
1 - 1 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.