Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
160 Posts
Discussion Starter · #1 ·
Does anyone know a good source of vector profiles for molding? I have a clock that I need to make a door with glass insert and I want to try my hand at making these on the CNC versus the router table. Just need a starting location for some ideas.
 

·
Registered
Joined
·
160 Posts
Discussion Starter · #3 ·
I found a couple of sites with profiles and am using those as a template to create my own. I'm learning!1
 

·
Registered
Oliver (Prof. Henry)
Joined
·
2,236 Posts
I just drew my own profile in Vectric V Carve, and used the moulding toolpath to cut it along a vector with a ballnose bit for the carving.
396667
396668
 
  • Like
Reactions: difalkner

·
Registered
Mike
Joined
·
3,941 Posts
If the profile is a standard profile then it is faster to use the bit in a router table to cut the profile. If you want something special then design it to be cut on the CNC. You can create some really unique moldings using your CNC so your projects all have your personal touch.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top