[reds_21]

Hello everyone!!!!

I am attaching a picture here of an aquarium that i have my eyes on at the local pet store. i have a question about the assembly of it (if you can help by looking at the picture). the aquarium stand seems to be made out of plywood. not sure if it's 100% plywood but the doors/framing were. the aquarium has a "wave" affect to it and i don't know how they go the "wave" appearance without practically bending the wood.

also, what power tools would be needed to make something like this? any help?

 

[reds_21]

thanks mike!!!

since the last time we spoke, i have not touched a single piece of wood. ive had a lot going on and just haven't had the time. come this spring i am shoting for time in the garage. hopefully i can complete a project!!!!!

as for the table saw, i have completely quit using it. prior to the last time we talked i was using my circular saw for everything mainly because i didn't have the support of a big table to support the wood for the table saw. so im trying to get away with a skil saw and circular saw if possible.

as the reading you provided me along with the article, the whole "wave" type fish tank seems rather difficult. i may try to build a nice "rectangle" stand for now and then bump to the "wave" later.

i am definately not gonna quit,,,just gotta find something I can do.

thanks again for your help!!

shawn