Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Is there a template available for the ash helper spring boards which have been used on a couple of The Router Workshop shows? The one show I recall was when they were used to hold the work to the fence while doing the 'V' groove on the edge of a plywood tabletop and half-round leaf for the solid wood edge.
 

·
The Router Guys
Joined
·
768 Posts
The big secret in building these spring boards is the straight grain at the thin part. Otherwise just use Tin-can-Geometry and design the spring board with ball on the front and a place to clamp on the back.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top