Fitting table tops
I was just browsing the forum,as one does from time to time, when I noticed a post by Mike dated March 5th. regarding fitting table tops. The method that I use is as shown, using Z clips (zed). It's so easy to rout a 1/8th" groove into the rails prior to assy. With the top upside down the frame is centred then fixed into position, what could be easier than that? I'm waiting for several replies with even easier methods! By the way, I did NOT make this particular coffee table but it was easier to take the shot in the warm family room rather than go into the shed on this chilly Easter Friday evening. Cheers for now, Harry
I was just browsing the forum,as one does from time to time, when I noticed a post by Mike dated March 5th. regarding fitting table tops. The method that I use is as shown, using Z clips (zed). It's so easy to rout a 1/8th" groove into the rails prior to assy. With the top upside down the frame is centred then fixed into position, what could be easier than that? I'm waiting for several replies with even easier methods! By the way, I did NOT make this particular coffee table but it was easier to take the shot in the warm family room rather than go into the shed on this chilly Easter Friday evening. Cheers for now, Harry
