B&D Router 7613 will not mount on a Bosch RA1181 table

1370 Views 6 Replies 4 Participants Last post by mschindler, Apr 28, 2020

mschindler

Discussion Starter · Apr 27, 2020

I have a Black and Decker router Model 7613. It will not mount to my Bosch RA1181 router table. Any suggestions or fixes for this?

Save

1 - 7 of 7 Posts

Stick486

· #2 · Apr 27, 2020

welcome to the forums N/A...

is because of the hole pattern???

Save

Welcome to the Greatest Router Circus on Earth! You’ll find it all right here...

Look online for the table manual and/or compatibility of your router with the table base plate. I kinda doubt there will be much Of a match, which means making your own holes. Or, move up to a router lift like the popular Jessem Rout-R-Lift II - it is compatible with many 3.5” diameter router motors. I really like mine and do several others here.

Save

Reactions: 1

mschindler

Discussion Starter · #4 · Apr 27, 2020

Thank you for your time and info.
Mike S.

Save

Tagwatts

· #5 · Apr 27, 2020

BRIAN, Do you know if the lift you mentioned will fit a Bosch Table?

Thanks,
Tagwatts1

Save

Bstrom

· #6 · Apr 27, 2020 (Edited)

Tagwatts1 said:
BRIAN, Do you know if the lift you mentioned will fit a Bosch Table?

Thanks,
Tagwatts1

I have the RA1181 Bosch table - you'll have to route 1/16" off each side of the Jessem's Rout-R-Lift II phenolic top to get it to fit. Not a problem unless that idea freaks you out. Not a biggie. I used the Bosch RA1181 leveling hardware and created the holes needed to fasten it down. Works beautifully!

See less See more

Save

mschindler

Discussion Starter · #7 · Apr 28, 2020

Thank you for your time and info.
Mike S.

Save

1 - 7 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

B&D Router 7613 will not mount on a Bosch RA1181 table

mschindler

Stick486

Bstrom

mschindler

Tagwatts

Bstrom

Attachments

mschindler

Top Contributors this Month