Router Forums banner
1 - 1 of 1 Posts

·
Retired Moderator
Joined
·
16,386 Posts
Good stuff Tom. My circle cutter was slightly different in that it had a strip under to run in the saw's miter slot so that you could advance the piece's edge into the blade which makes starting the cut easier and straighter. The pivot pins have to line up at 90* to the front of the blade when the stop hits the edge of the table.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top