Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
558 Posts
Have a look at the router table used on the router workshop or look at the offset style at woodpecker's. They both male better use of the space than sticking it right in the center. I also agree with Bob Rosendahl and Pat Warner don't weaken the table by cutting a miter slot, make a sled (holder) instead.

Regards

Jerry
 

·
Registered
Joined
·
558 Posts
Most miter slots are big enough to allow a 3/8 x 3/4 bar to slide in them and yes I think this will eventually compromise the table.I didn't mean a sled holder I meant a sled or a carrier that references off the fence,or something else stationary that a piece may be clamped to.Have a look at oak-park.com -raised panel jig- that might make it cleareRegards
Jerry
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top