Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello I started building my router table top last weekend and I have a question. What would be the best place to put the base plate in the table top? The top is 24 x 36 and because Iv'e never used or seen anyone els use a router table I don't have a clue were would be best for practical usage
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
Thanks for the reply Iv'e seen lots of pics of different router tables and the different locations of the base plates I'm just trying to deside which way would be best for me to go. I have no idea what you mean by a sled holder I made my table top out of two counter tops I got for free,I glued them together laminate sides out and then cut to size so the table is prety solid do you think a 1/4 inch deep miter would weaken it all that much?
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #8 ·
I wasn't planning on cutting a slot for a miter in my table, please let me apologize for my on stupidity I misunderstood what jerry was talking about in his first reply to my question. I would like to thank everyone for there opinions though.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top