Router Forums banner
1 - 1 of 11 Posts

· Registered
335 Posts
Use 4 screws- 1 in each corner from the under side of the table. The screws contact your baseplate and are used as adjustments to keep the plate flush with the tabletop. View labric's 2nd photo. Notice the black plate is nearly flush with the tabletop. If the two are not flush, your stock with be stopped as you push. -Derek
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.