Router Forums banner
1 - 8 of 8 Posts

1,976 Posts
Discussion Starter · #1 ·
Hi guys.
After many years of use and abuse, the back support of the chair´s pillow broke down and need to be repaired.
I disassembled the seat and rescued the fabric to be reused. Then, using a piece of 10mm plywood cut to length, some cement contact glue, the same foam and a lot of 6mm staples I did some basic upholstery to repair the pillow.
Here are the pictures.


1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.