Router Forums banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
201 Posts
Discussion Starter · #1 ·
I have the Bench Dog ProMaxRT cast iron table with BD Pro Fence which I purchased with metal cabinet from Rockler. I make several pieces that require mortise & tenon cuts. I need a micro adjuster for this setup, especially one that will accurately pull the fence back from the bit.

I've looked at buying an adjuster however most would need mods to work with this fence. I'm also considering building one from scratch. Do any of the forum members have a micro adjuster for this Bench Dog fence that works well?
 

·
Premium Member
Joined
·
201 Posts
Discussion Starter · #4 ·
I've considered both the Rockler & Kreg models. I will likely use one of those with some mods to enable accurate pull back from the bit.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top