Router Forums banner
Cancel

Posts by Virginia Traveler

Jump to Latest Follow
1 - 1 of 9 Posts
V

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am new to routing. My first project is to cut a dado in a Azek trim board. Azek literature says to use a straight bit that is carbide tipped. Is there a specific carbide tipped bit that anyone on the forum would recommend? Thanks!
 
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
8 Replies
9 Participants
Last post:
MEBCWD
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top