Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,474 Posts
Looking on the Lee Valley site they show the router being used as the Hitachi 3.5 hp model.

IMO I'd look for a router that is plunge and comes as high as possible to the base for ease of changing bits.
 

·
Registered
Joined
·
1,474 Posts
I have a Bosch 2.5 pulunge and don't like it because of the tightness around the baseplate.
The routers I use the most are a PC 7581 it is basically just a moter as the whole base was remove and is in an Incra table w/twin leanear fence.
In the router workshop table I use a Dewlt 625.
Both of these get a lot of use and I guess i like them equally.

I have the hitachi also and it is set up with the large hole router workshop plate and for a hand held i use a Fien.

The Fien is an excellent hand held router.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top