Joined
·
1 Posts
Please recommend an appropriate sized tool setup for this job:
Replacing Rotted Horse Stable Slats:
Job Description:
Tongue and groove routing of 1344 board feet of 12 foot lengths of 2 by 6 Yellow Kiln Dried Pine (That's 112 quantity of 12' lengths 2"x6" Boards)
I am thinking of a router table & router combo of some sort.. please advise..
If anyone can recommend the proper equipment and estimate the cost and type of bits to finish the job that would be even better! I don't know much about routing!
Grooves look to be 1/2" by 3/8"
I've included photo's to show what I'm trying to do....
Replacing Rotted Horse Stable Slats:
Job Description:
Tongue and groove routing of 1344 board feet of 12 foot lengths of 2 by 6 Yellow Kiln Dried Pine (That's 112 quantity of 12' lengths 2"x6" Boards)
I am thinking of a router table & router combo of some sort.. please advise..
If anyone can recommend the proper equipment and estimate the cost and type of bits to finish the job that would be even better! I don't know much about routing!
Grooves look to be 1/2" by 3/8"
I've included photo's to show what I'm trying to do....
