Router Forums banner


1115 Views 2 Replies 3 Participants Last post by  Mark
Benchdog prolift, while using raised panel cutter, has a tendency to climb up even when the lock is secure. Was wondering if anyone else has had similar problems and what to do to correct this problem. The lock screw loosens as the panel is being cut resulting in unusable panel
1 - 3 of 3 Posts
Welcome to the forums BigHitter. Glad to have you with us.

the "Doctor"
Hey bighitter, welcome to the forums!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.