Router Forums banner
1 - 4 of 10 Posts

· Administrator
David - Machinist in wood
Joined
·
4,604 Posts
Discussion Starter · #1 ·
This is a topic that came up recently on Woodworking Talk so I thought I'd shoot a short video to see just how much my blade wobbles at startup. Turns out it's fairly slight and is over in about one second. The video is less than two minutes if you're interested in watching.
 

· Administrator
David - Machinist in wood
Joined
·
4,604 Posts
Discussion Starter · #3 ·
Might want to consider replacing with a new belt and improve the belt-pulley alignment and tightness.
Worn or hardenned belt may be causing the wobbling.
Nope, not considering any changes at all. All three matched set drive belts are good, tight, the blade cuts as it should, and the wobble goes away in about one second. It's done this from the start and hasn't gotten any worse, so like I said in the video - all is good.
 

· Administrator
David - Machinist in wood
Joined
·
4,604 Posts
Discussion Starter · #9 ·
1 - 4 of 10 Posts
Top