Router Forums banner
1 - 1 of 13 Posts

· Registered
252 Posts
I've been using a Bosch 1181 router table for a couple of years now. While mostly it's ok, I am a bit fustrated on setting the fence distance to the bit. There are 2 knobs on each side and a cheesy distance gauge. It's hard to get the distance dead on with out some trial and error.

Recently, I was somewhat foiled when cutting a sliding dove tail joint using a 14 degree 1/2" bit. The side where you cut down the middle is fine, it's the other side where you take 2 cuts on each side of the "pin" which is tough. You are supposed to cut a little bit off, on each side, until it fits. This is like 1/32 or even 1/64 for a cut. That's hard to get set with this type of fence. I am tapping just a wee bit, but it's hard to do on both sides and know how far you've moved it. I was wondering if there are suggestions for a better way to go at this.

Dirk Herr-Hoyman
Before I got my Incra router table fence, I would use a stop block and automotive feeler gauges. Pivot the fence about one end and rotate the other end.
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.