Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Hi
may I ask if the "locking bit holder" which is what Bosch calls the quick chuck assembly on the above drill, allows the driving bit to go into the armature fitting on the above drill? Does the bit wobble at all like on most drill drivers?
thanking you in anticipation
Peteroo
 

·
Registered
Oliver (Prof. Henry)
Joined
·
2,229 Posts
The bit does not go all the way into the motor's hex drive when using the locking bit holder, however the driver can be used without any of the accessory holders. Regardless of which method you choose, there is still the inherent wobble encountered with most drill drivers. The wobble isn't a problem for me because I don't use the tool when I need precision drilling. I have found the offset, right angle, and keyless chuck attachments to be very useful.
 
1 - 2 of 2 Posts
Top