Joined
·
3,456 Posts
Using my 1617 the other day, noticed that a part (nut) had come loose. Part # 29 in the diagram labeled as "Nut" was loose and sitting above the collet.
Tried to tighten it up but found there was very little room to get two wrenches in there. I'm guessing this should be more than "finger tight". Any suggestions?
Tried to tighten it up but found there was very little room to get two wrenches in there. I'm guessing this should be more than "finger tight". Any suggestions?
Attachments
-
27.2 KB Views: 276