[nelsonmay]

I finally started to build my table today. I have been searching and can't get an answer to my question. I don't know how to ask it so here goes.

1. I have a Bosch 1617EVS Router and don't know how to map the 3 holes to screw it to the 3/4 ply and mount it. I went though my instruction manual and there isn't a templet or centering guide. I may not be seeing it, but it is in the holes of the plastic plate I removed? How do you guys solve this sort of thing when you make a new table?
2. I have some 1/2 polycarbonate laying around. I am not ready to get a plate yet, but can I make one from the 1/2 inch poly? Will it hold the stress?

Thanks in advance.

 

[nelsonmay]

One more question?

Thank you guys for the info. I went ahead and bought the Rockler router table assembly that was on special for 229.00 with 20 percent off. I am spending too much time as a beginner building a table and not learning the tool. I can buy plates later as I need them. I can also build a larger table later. I just have a few projects to get done before I give them as presents.

Anyway, they table is press board. It is exposed on the underside and edges. I have a basement that gets water leaks and I also live in Atlanta. GA, where is is very humid. Do you guys recommend adding a lacquer or polyurethane coat to the exposed wood to seal it? Would I even need to do this?

Thanks.