Router Forums banner
1 - 1 of 1 Posts

3 Posts
Good Luck

Well I ordered the Bosch 1619 EVS from and received it today.I plugged it in to see if it would run then I put it right in the table. Luckily it and a couple of Accessories that I ordered qualified for the free shipping and the $300/75 off deal. I have not ran any wood through it yet but will put it to the test tomorrow. My shop is full of stuff I just finished putting varnish on.

I like the way it is set up for disabling the springs and for table adjustment use. But more of that will come in the tool review area.
Hope you have better luck than I did. You may want to check to see when it was made.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.