Router Forums banner
1 - 4 of 7 Posts

· Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
I bought a used 4000 and the owner had 'lost' the guard/riving knife combo. I don't care about the guard part but I'd like to find a riving knife that will fit the saw. I've seen YouTube videos on fabrication of one but this is beyond my tools that I have.
Does anyone have an idea.
Thanks
Andy
 

· Registered
Joined
·
120 Posts
Discussion Starter · #5 ·
From the first time I ever used a table saw (1953/4), have never used one. In fact took the one off my present saw the day I got it home (bought new). But I do not recommend you try that. I have more experience, and am very, very, careful. Never had an accident on one. But you likely would if you tried it.
It's not the Guard I want. And I have plenty of experience running a TS, just not at home.
I've had plenty of cut off boards fly past me by. And like the rule says "There are two types of TS operators, those that have been cut and those that will" and I would rather not join the latter.
 
1 - 4 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top