Router Forums banner
1 - 10 of 10 Posts

· Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Hi everyone, I am brand new to the group. I recently purchased the above stamped steel Bosch router table saw extension, (27” X 10” X 1-1/2”). I have been looking for printed information on the extension for my files. I was also looking for replacement 2” OD round inserts that snap in to the table top. There appears to be a total of 4. I don’t have the extension here yet, but the ID’s I am guessing start at 1/2”, 3/4”, 1” & 1-1/2”? I would appreciate any wisdom and ideas for replacements. I did try the Bosch tool website, but nothing was found. Worst case I may need to find someone who does 3D printing and send them the inserts to copy. I know too there are folks out there who might know how to fabricate them from aluminum sheets.
Thank you to all! Jim
 

· Registered
Joined
·
621 Posts
Hi everyone, I am brand new to the group. I recently purchased the above stamped steel Bosch router table saw extension, (27” X 10” X 1-1/2”). I have been looking for printed information on the extension for my files. I was also looking for replacement 2” OD round inserts that snap in to the table top. There appears to be a total of 4. I don’t have the extension here yet, but the ID’s I am guessing start at 1/2”, 3/4”, 1” & 1-1/2”? I would appreciate any wisdom and ideas for replacements. I did try the Bosch tool website, but nothing was found. Worst case I may need to find someone who does 3D printing and send them the inserts to copy. I know too there are folks out there who might know how to fabricate them from aluminum sheets.
Thank you to all! Jim
would these fit?
Outer diameter 3 3/4"
 

· Registered
Joined
·
621 Posts
Hi, thank you for responding. The gentleman I bought the wing from said the inserts that came with the table have a 2”OD, so these would be too big. Again thank you.
on ebay
 

· Official Greeter
Joined
·
20,404 Posts
Welcome to the forum..
 
1 - 10 of 10 Posts
Top