Router Forums banner

Bosch Deluxe Edge Guide

1370 Views 9 Replies 4 Participants Last post by  Herb Stoops
2
Remember a while back there was a discussion here about the center pivot for circle cutting?
I finally got around to scanning a picture of what mine looks like...totally different from the others described.
Bosch is obviously having an issue nailing this down...

Attachments

See less See more
1 - 10 of 10 Posts
is that one pliable like a suction cup???...
No; it's hard plastic...acrylic maybe?
No; it's hard plastic...acrylic maybe?
never had do deal w/ that type...
did you get the pivot pin that looks like a duplex nail???
time to get industrious...
Nope. What's in the pic is it. Actually nailing it down is a pain...those slots are just too small.
Nope. What's in the pic is it. Actually nailing it down is a pain...those slots are just too small.

Go past nails at the speed of light...tape works much better...
Yaknow, it just occurred to me, perhaps those slots are actually for lining up the pivot plate with penciled cross hairs rather than for nailing it down. Using tape would then make perfect sense.
  • Like
Reactions: 2
Yaknow, it just occurred to me, perhaps those slots are actually for lining up the pivot plate with penciled cross hairs rather than for nailing it down. Using tape would then make perfect sense.

Yep-er-dee-doo-dah...:smile:
Yaknow, it just occurred to me, perhaps those slots are actually for lining up the pivot plate with penciled cross hairs rather than for nailing it down. Using tape would then make perfect sense.
exactly...
The one I have looks like a small plumb bob.
HErb
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top