Router Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi,

I read a lot of interesting info on this forum. I was out of woodworking for some time. Its a hobby, but didn't have time for iz lately.
Recently bought Bosch GMF 1600CE. Im quite happy with it, its an upgrade from Makita RP0900.
Is it possible to set heigth when tablemounted in fixed base with a little key provided, WITHOUT releasing body clamp under table?
As i see it now, its not possible??? Little dissaponting

Tnx
 

·
Registered
Joined
·
31,264 Posts
you must release the clamp....
 

·
Registered
Mike
Joined
·
3,940 Posts
You might be able to release the clamp from above the table, check your manual.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
In the manual, there is not much about table mounting. That's why i thought maybe im doing someting wrong. Its a bit complicated to unlock the clamp every time i want to change the bit heigth. But looks like that is the way it is, unfortunately. Thanks guys
 

·
Registered
Joined
·
1,936 Posts
In the manual, there is not much about table mounting. That's why i thought maybe im doing someting wrong. Its a bit complicated to unlock the clamp every time i want to change the bit heigth. But looks like that is the way it is, unfortunately. Thanks guys
Probably the worst thing about this router, of which I own 2 of the US model, is the manual. Be warned about what can happen
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #7 ·
It almost happened. to me when i tried to change bit height while the clam wasn't released. Thats how i got to conclusion that it has to be unclamped.
Tnx for the tip anyway
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top