Joined
·
4,625 Posts
Welcome to the Forum...
I believe you are correct...speed control unit.
You might try taking it apart to make sure the sensor is clean of any fine sawdust and that all the wires are connected properly and not loose...
The sensor typically sits above the rear of the shaft and can be removed easily with screws. The sensor looks at the shaft spin to determine its speed.
I believe you are correct...speed control unit.
You might try taking it apart to make sure the sensor is clean of any fine sawdust and that all the wires are connected properly and not loose...
The sensor typically sits above the rear of the shaft and can be removed easily with screws. The sensor looks at the shaft spin to determine its speed.
