Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I recently acquired a Bosch RA1181 router table. I noticed the fence is not perpendicular to the table, and I do not see any obvious way to adjust the fence nor is there anything in the owners manual. Anyone have a solution?
 

·
Official Greeter
Joined
·
19,858 Posts
Welcome to the forum.
 

·
Super Moderator
John
Joined
·
6,963 Posts
Hello and welcome to the router Community
 

·
Registered
Joined
·
23,786 Posts
Hi

You must put the table saw out of your mind the fence can be anywhere on the top unlike a table saw ,think of it more like a drill press ...one point of cutting..

====
I recently acquired a Bosch RA1181 router table. I noticed the fence is not perpendicular to the table, and I do not see any obvious way to adjust the fence nor is there anything in the owners manual. Anyone have a solution?
 

·
Retired Moderator
Joined
·
16,385 Posts
If you mean that the face of the fence is not vertical to the table then there is no easy fix for that. I would return the fence if it is new. It will make some operations impossible and almost all others difficult.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top