[JamRam]

I'm niewbie and would like to route a 30mm wide channel (300mm x2 ) would it be possible and safe to use bottom clearing bits for the job?

 

[sunnybob]

Thats confusing. Youre not clear on your aims.
What wood? how deep?
length of cut is not relevant on a router table.

 

[JamRam]

Thats confusing. Youre not clear on your aims.
What wood? how deep?
length of cut is not relevant on a router table.

hi,

forgot to mentioned i dont have router table, only by free hand. I need to cut a channel approximately 2mm deep and 30mm wide, Material is MDF.

thanks

 

[sunnybob]

2 mm deep x 30 mm wide is fine. make sure you have a secure straight batten clamped to the piece to run the router along, otherwise the cut will wander all over the place,

 

[Rebelwork Woodworking]

.....