Router Forums banner
1 - 1 of 4 Posts

· Registered
175 Posts
Discussion Starter · #1 ·
Hi there fraternity
Well that’s my bowl Turning days over

After some minor initial success my career as a turner extanour came to an abrupt end with me experiencing the catch of all catches on a bowl I had just started.

The result being I am sitting up in bed a Ninewells hospital sheduled for surgery tomorrow morning

I successfully ripped my index finger open from end to end. Top and bottom and even managed to smash the bone into pieces at the same time.

I can’t point the finger at anybody as it was my lack of experience in fact I can’t point the finger at all.

Will be in special splints for a couple of months and I now have a wood lathe being retired on orders of my good wife. Can’t say I disagree with her as it was to date my worst inflicted accident and pretty traumatic as well.

Can’t give enough praise to the hospital stall. Arrived at A&E at 2pm and was assessed and scheduled for my operation next day by 4pm
Luckily here in the UK health care is free so don’t have the additional burden of costs. They had me on the table and brought in plastics surgeon that special isles on rebuilds to hands. The X Ray shows that the bones were in confetti and I’m out of action for a few months providing the healing takes

Unfortunately for my wife we are going to be spending a lot more time together. She hasn’t realised it yet

She was right about the COM being chump of the month

I think she asked the surgeon if recovery would be quicker if they just cut the finger off.

What’s left of my finger is suspended in the white bag in the photo. It has to be kept above the heart at all times

So lads, no projects to write about for quite some time, but I have a feeling that the amount of time spend together may throw up something interesting , although she has been extreme attentive, but I suspect that is just to speed up the recovery time.



1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.