[bobj3]

Hi John

End of the boards would be the one below

Finger Joint Router Bit
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_box_finger_joint.html#finger_joint_anchor
http://www.grizzly.com/products/Shaper-Cutter-Finger-Joint-3-4-Bore/C2124

T & G bits on this page should do the job for the side by side

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_tongue_groove.html
http://www.grizzly.com/products/Shaper-Cutter-1-4-Tongue-Groove-Set-1-2-Bore/C2310
http://www.grizzly.com/products/C2028
http://www.grizzly.com/products/C2029


===========

Question;;Were interested in engineered wooden beams.Do you have a tool
or jig to use on our router or wood shaper to join (end to end) 1x6
lumber?Also,we'd like the same for side by side lumber.

Godbless,
John Higgins
Camiguin,Philippines