Router Forums banner
1 - 1 of 7 Posts

· Premium Member
508 Posts
Boyd Howard said:
Where would a guy get information about how to make a special cabinet mold using a combination of router bits?

What good is the fence if the roller bearing must rest against the side of the workpiece?
Hello Boyd Howard, Welcome to the RouterForums :)

I have had the same question before and have used several different bits to get the molding look I wanted. There is a bit that I am ordering soon from it is the Multiform Bit 1/2" Shank I make all of my own molding and trim with different bits already. So I thought I would try this one to see how it would work.

Moved to Table Mounted Routing.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.