Router Forums banner
1 - 2 of 7 Posts

· Registered
208 Posts
When Iam using more than a single bit for a "custom" molding I draw the profile of the molding that I want then use those bits that fit segments of the molding that I have drawn. Usually this does not involve more than 3 bits. I usually have to use the fence rather than the bearings on the bits which means straight stock only & in my case for picture framing.

1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.