Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,711 Posts
I was actually considering cast iron wheels like these.

Perhaps on a 3/4 in plywood base? I am not sure this would be adequate.....
Those casters are rated at 300lb each, so they should do the job. Think I would double up the 3/4 plywood tho.

Did you buy the Shop Fox new or used? If it's new I would just have it exchanged! You can get a bad one of just about anything! If you bought it used, just have it rewelded. I'd offer to do it, but the distance is probably too far for either of us! I have had my 450lb band saw setting in one of them(Shop Fox mobile bases) for the last 6 or 7 years with no issues! The cost of the 4 casters alone is close to the price of the Shop Fox base!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top