Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
I am thinking of building a shop, and was looking for suggestions of how much room I need, the best layout, electricity, or any advice you might have on setting up a shop. I have alot of my tools listed on my profile to give you an idea of what I have. There is a PSI dust collection system that I am not sure how to set up either. My slide compound saw is mounted to a 10 foot table with built in rulers, and there is a 6 foot table for a table saw (I think.. it has steel plates on it and rulers) with the Exact-I-Rip attached to it. Or could that be a router table? All other bigger tools are attached to stands as well if that is an option for them. Plus there is a big blue filter that I am not sure how to hook it up.

Thanks ahead for any tips you might have! I am new to this, and figured I have been given this gift of tools, I should do something with them!

Adrienne
Fine woodworking has a nice shop planner and good information

finewoodworking.com/workshop-planner
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top