Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I want to make a bull nose for a tread. But when I cut the plywood and stain, the sides get very dark. How to avoid the dark side on the plywood.it is my intention to do it from a 3/4 and 1/4 inches. glue them ip and use a router bit to give the shape of bull nose. The problem is the stain. How to avoid the dark side. How to avoid that part of the bull nose to suck up too much stain
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top