Joined
·
4,625 Posts
I have a Rikon and it has served me well...good pricing on them also. I have the 10-325...I think the new ones are 10-326...14"
Good roller bearings for guides, easy screw adjustment, easy to align (I use Alex Snodgrass) and it stays in alignment. Has a quick release tensioner that I always use after I'm done cutting.
Cast iron table, tilting to 45+, plenty of throat. the 14 will resaw to almost 14" (no riser needed).
I have used blades from 3/16 to 1/2" so far...3/4 tooth 1/2" for resawing...tracks straight as an arrow...
Great support from their technical team also...needed to align the blade guide to be straight up and down at all heights...they helped quite a bit.
4" port for dust collection...works great... Sucks dust from under the table by the lower guide...
...take a peek...you might like...
Good roller bearings for guides, easy screw adjustment, easy to align (I use Alex Snodgrass) and it stays in alignment. Has a quick release tensioner that I always use after I'm done cutting.
Cast iron table, tilting to 45+, plenty of throat. the 14 will resaw to almost 14" (no riser needed).
I have used blades from 3/16 to 1/2" so far...3/4 tooth 1/2" for resawing...tracks straight as an arrow...
Great support from their technical team also...needed to align the blade guide to be straight up and down at all heights...they helped quite a bit.
4" port for dust collection...works great... Sucks dust from under the table by the lower guide...
...take a peek...you might like...
