Router Forums banner
1 - 1 of 1 Posts

·
Marine Engineer
Doug
Joined
·
4,960 Posts
Tom,

When I upgraded my table saw, I was originally planning on getting a Grizzly 1023 series table saw. I had checked them out at the Muncy PA store on one of my pilgrimages to the tent sale they have. I was impressed with the size and mass of all the pieces, and the general overall quality.

I didn't end up buying the saw, because the delivery time at the time I was ready to purchase was a bit longer than I wanted to wait, and during that time I got a deal too good to pass up on my second choice of table saw.

I don't think you'ld be dissapointed with the grizzly saw. I have the 14 inch ultimate bandsaw, a 1-1/2 HP dust collector and a drill press from grizzly, all respectable tools in their own right. If you get a chance, go to one of their showrooms. It's a neat experience to be able to see their entire inventory on display.

As for the router bits used on the router workshop, I know oak park used to sell bits, don't know if they still do. Most of your major bit brands have a majority of the profiles that Bob and Rick use available.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top