Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
782 Posts
Discussion Starter · #1 · (Edited)
here is some buckeye wood i made from a 4" slab that wasn't doing anything I resawed it Than i made a slad and used the Bosh 1617 that i just got With a 3/4" dado bit and made it aprox size on both sides The 11" router plate that fits the 690 porter cable routers Fit this router just right Lucky i guess the wood was to lite and knotty for the planer I ran the router for aprox 1/2hr. and the motor didn't get warm Sure sold on this router I like the micro adjust on the base to raise and lower The wood doesn't have the golden color tell you put a finish on it Than it sure jump's out at you thanks for reading del
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top