Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I would like to rout a graded cavity for a carving board. It will be shallow at one end and get deeper as the cavity progresses along the carving board. The idea is to use the cavity to hold the meet while is it being carved.

What type of jig would I use to get a nice smooth floor in the cavity.

Thanks

Garry
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top