Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
120 Posts
I use both a chamfer bit and roundover bits in a table to make my own cupboard handles.
I had some square shaped handles on some furniture I inherited from my parents and decided to use similar handles on a TV corner unit I made and a computer desk I am making.
I used some 3x1 timber and cut square sections from it.
I then routed half way through with a chamfer bit and rounded over the other side.
The chamfered sides go against the doors so my fingers go behind them when opening the doors and the rounded over part is seen from outside.
A 1" coving bit might have been better than the chamfer bit I'm the only one who is likely to notice.
Routing the wood was easy before cutting to length but more difficult when short.
This was overcome by making a jig to hold them all in a line so that once clamped I could route them all at the same time.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top