Router Forums banner
1 - 1 of 14 Posts

· Registered
5 Posts
I see all of these good recommendations of circle cutting jigs for portable routers, but, can anyone recommend jigs for router tables? I need to make a number of uniformly-sized wheels that have been roughly sized (witha circle cutting jig) on a bandsaw and thought a similar setup would apply to a router table. Would need to know which direction the blank should rotate; location of where the bit should be cutting into the blank; angle of the jig relative to the bit.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.